Select the battery-release latch and press down into it with one hand, and then pull the battery out of your case, setting the netbook battery aside.
The convenience given by the portability of a norebook can
become a hindrance due to screen malfunctions? it is absolutely not easy to
connect a new monitor since you can with a desktop structure. If the backlight
in the LCD screen has failed, you can see any image. To fix the
problem, the entire inverter board will be connected LCD cable must have
to be manually swapped. Here below are the instruction for a
reference.
1. Check in your manual of your laptop computer or search the infomation out of
the Internet to support the a natural part of the manufacturer抯 websites. Only
get that what model fo inverter board you may need for your computer, get
my Pavilion DV2000 Panel as instance, I get a right one from an honest site, HooToo. com, after which it i fix it without any help.
2. Turn off typically the laptop抯 operation system. Power down the LCD screen
top. CTurn the whole laptop over so your bottom end of the case is facing
up on to you. Locate the battery-release latch and press down into it
with one hand, and then pull the battery out of your case, setting the netbook battery aside.
3. Locate the rubber pieces at the edges and the surface of the LCD. Pop the
stopper pieces from the case by inserting a designated object underneath
them after which it pulling out toward you. Use a screwdriver to withdraw the
screws hidden beneath the stoppers.
4. Put the notebook back over and open up the LCD screen back off.
Slide a flat not to mention thin object, such being screwdriver, directly
underneath the seam of this plastic bezel underneath the actual LCD screen.
Wiggle the screwdriver along gently until the bezel pops there are various
case. Lift the bezel up and verify if there is a good cable running to
your motherboard. Disconnect the cable if you find one.
5. Pull true on the screen closer, and then remove it again from
the laptop. Locate the inverter board in the bottom of the screen not to mention
find the cable running out of your inverter board to typically the motherboard. Pull
off the strip of tape at the board and remove a screws holding it with
place if there are any within your particular model of pc. Disconnect
the cable through the motherboard.
6. Connect typically the motherboard cable for naff bezel and place the actual bezel
back onto typically the laptop case. Finally, just put the battery in the laptop
and power it again on, and then if your manufacturer抯 logo appear at the
screen, it mean you are successfull to install the ultra-modern inverter
board and conductor rightly.
Article Tags:
Inverter Aboard
